Yesterday, we had one host in our recovery site PSOD, and that caused all kinds of errors in Zerto, primarily related to VPGs. In our case, this particular host had both inbound and outbound VPGs attached to it’s VRA, and we were unable to edit (edit button in VPG view was grayed out, along with the “Edit VPG” link when clicking in to the VPG) any of them to recover from the host failure. Previously when this would happen, we would just delete the VPG(s) and recreate it/them, preserving the disk files as pre-seeded data.
When you have a few of these to re-do, it’s not a big deal, however, when you have 10 or more, it quickly becomes a problem.
One thing that I discovered that I didn’t know was in the product, is that if you click in to the VRA associated with the failed host, and go do the MORE link, there’s an option in there to “Change Recovery VRA.” This option will allow you to tell Zerto that anything related to this VRA should now be pointed at X. Once I did that, I was able to then edit the VPGs. I needed to edit the VPGs that were outbound, because they were actually reverse-protected workloads that were missing some configuration details (NIC settings and/or Journal datastore).
- Log on to the Zerto UI.
- Once logged on, click on the Setup tab.
- In the “VRA Name” column, locate the VRA associated with the failed host, and then click the link (name of VRA) to open the VRA in a new tab in the UI.
- Click on the tab at the top that contains VRA: Z-VRA-[hostName].
- Once you’re looking at the VRA page, click on the MORE link.
- From the MORE menu, click Change VM Recovery VRA.
- In the Change VM Recovery VRA dialog, check the box beside the VPG/VM, then select a replacement host. Once all VPGs have been udpated, click Save.
Once you’ve saved your settings, validate that the VPG can be edited, and/or is once again replicating.